May 28, 2012

Prefab work aiding completion of MaineGeneral's new hospital

By Betty Adams badams@centralmaine.com
Staff Writer

AUGUSTA -- The region's newest hospital is about one-third complete and construction is moving along rapidly.

click image to enlarge

Construction workers are seen climbing among the girders during a recent tour of MaineGeneral's new regional hospital under construction in North Augusta.

Staff photo by Joe Phelan

click image to enlarge

Workers on lifts are framed in a window of MaineGeneral's new regional hospital under construction in North Augusta.

Staff photo by Joe Phelan

Additional Photos Below

Builders are taking advantage of cost- and time-saving methods by prefabricating exterior panels and interior bathroom shells as well as frames which hold medical gas lines, electrical power and in-room monitoring equipment.

John Scott, senior project manager at the site of MaineGeneral Medical Center's 192-bed regional hospital, said the work schedule incorporates some of the savings gained by prefabricating structures on site.

However, he added, "We're being cautious in our projections."

HP Cummings, which has offices in Winthrop, is partnering with Alabama-based Robins & Morton on the construction management.

Scott was reluctant even to give the 30 percent complete estimate as visitors stood outside the rear of the building, which already has its exterior brick facing.

The current completion date projection came from Chuck Hays, president and chief executive officer for MaineGeneral Medical Center.

The $312 million hospital, which is between Interstate 95 and Old Belgrade Road adjacent to the Harold Alfond Center for Cancer Care, is projected to open by the end of 2013, about six months earlier than originally anticipated.

"What we're targeting is the beginning of December 2013," Hays said. "Until we have the building weather-tight, which should be by the end of this summer, then we can come up a more firm date."

Prefabricating for fittings for patient rooms takes place on the first floor where racks of metal frames for the equipment headwalls destined for each patient room stand against one concrete wall.

Studding for the headwalls that stand behind the 192 patient beds begins at Porter Panel & Truss, a division of Porter Drywall in Portland, and the frames are shipped for finishing at the hospital.

Ivan Stevens, also of HP Cummings, who oversees the prefabrication on-site prefabrication, said workers -- generally a crew of two electricians, two plumbers and one carpenter -- turn out three or four headwalls a day, and have been working on bathrooms also for the past several weeks. A dozen of those were in various stages of being fitted out.

They have sliding doors instead of swinging doors and European showers without a threshold, making them compliant with the Americans with Disabilities Act.

"The amount of labor it takes doesn't change, but doing the work ahead of time shrinks the schedule," Scott said. "We can be sheet-rocking a room much quicker." He said prefabrication allows for continuous improvement as well.

New rooms

Rooms in the new hospital will differ from those at the two in-patient hospitals operated by MaineGeneral Medical Center in Augusta and Waterville because all the beds will be in private rooms, and each room will be fitted with a patient-lift device and have a sofa or chair that converts into a bed so someone can stay with the patient.

Several of the convertible furniture options were arrayed around a large conference room at construction headquarters. And soon, a mockup of one of the new hospital's patient room will be set up at the Seton site in Waterville.

Hospital spokeswoman Diane Peterson said that will allow hospital staff to see what the new rooms will be like.

The new hospital is designed with a main corridor for public use at the front of the building and a more private, rear corridor for patient transport and service areas.

The interior of some sections of the hospital already divides into corridors, rooms, courtyards, and penthouses with mechanical equipment.

Several people easily could walk abreast in the ductwork running through the mechanical equipment penthouse that serves the 10 operating rooms.

"They need a lot of air changes," Scott said. Several of the operating rooms are larger than the standard 600-square-feet and the extra room will allow them to "embrace technology."

(Continued on page 2)

Were you interviewed for this story? If so, please fill out our accuracy form

Send question/comment to the editors


Additional Photos

click image to enlarge

The walls of the loading dock already have the brick finish as other stages of construction are seen behind them at MaineGeneral's new regional hospital under construction in North Augusta.

Staff photo by Joe Phelan

click image to enlarge

Workers are prefabricating the walls behind patient beds with wiring and piping before they're installed upstairs at MaineGeneral's new regional hospital under construction in North Augusta.

Staff photo by Joe Phelan

 


Further Discussion

Here at KJonline.com we value our readers and are committed to growing our community by encouraging you to add to the discussion. To ensure conscientious dialogue we have implemented a strict no-bullying policy. To participate, you must follow our Terms of Use.

Questions about the article? Add them below and we’ll try to answer them or do a follow-up post as soon as we can. Technical problems? Email them to us with an exact description of the problem. Make sure to include:
  • Type of computer or mobile device your are using
  • Exact operating system and browser you are viewing the site on (TIP: You can easily determine your operating system here.)